Power Brake Booster Outlet Hose Replacement

Power Brake Booster Outlet Hose Replacement

Removal Procedure





1. Notice:
Refer to Power Steering Hose Disconnected Notice in Service Precautions.

Install a drain pan under the vehicle.

2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Remove the power brake booster outlet hose (1) from the power brake booster (2).
4. Raise and support the vehicle. Refer to Vehicle Lifting.





5. Through the wheel well disconnect the power brake booster outlet hose from the power steering gear (2).
6. Remove the power brake booster outlet hose from the vehicle.

Installation Procedure

1. Notice:
Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.

Route the hose in the same position the hose occupied prior to removal.





2. Notice:
Refer to Fastener Notice in Service Precautions.

Install the power brake booster outlet hose (1) to the power brake booster (2).

Tighten the hose fitting to 33 Nm (24 ft. lbs.).





3. Through the wheel well connect the power brake booster outlet hose to the power steering gear (2).

Tighten the hose fitting to 33 Nm (24 ft. lbs.).

4. Lower the vehicle.
5. Bleed the power steering system. Refer to Bleeding the Power Steering System.
6. Remove the drain pan from under the vehicle.