Power Brake Booster Inlet Hose Replacement

Power Brake Booster Inlet Hose Replacement

Removal Procedure





1. Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.

Install a drain pan under the vehicle.

2. Siphon the power steering fluid from the reservoir to prevent excessive spillage.
3. Raise and support the vehicle. Refer to Vehicle Lifting.
4. Remove the tire and wheel.
5. Remove the power brake booster inlet hose (2) from the power steering pump (1) through the wheel well.
6. Lower the vehicle.





7. Remove the power brake booster inlet hose (1) from the power brake booster (2).
8. Remove the power brake booster inlet hose from the vehicle.

Installation Procedure





1. Notice:
Refer to Installing Hoses Without Twists or Bends Notice in Service Precautions.

Route the hose in the same position the hose occupied prior to removal.

2. Notice:
Refer to Fastener Notice in Service Precautions.

Install the power brake booster inlet hose (1) to the power brake booster (2).

Tighten the hose fitting to 33 Nm (24 ft. lbs.).

3. Raise the vehicle.





4. Install the power brake booster inlet hose (2) to the power steering pump (1) through the wheel well.

Tighten the hose fitting to 33 Nm (24 ft. lbs.).

5. Install the tire and wheel.
6. Lower the vehicle.
7. Bleed the power steering system. Refer to Bleeding the Power Steering System.
8. Remove the drain pan from under the vehicle.