Oil Pan Replacement - Lower

Oil Pan Replacement - Lower

Tools Required
^ J37228 Seal Cutter

Removal Procedure





1. Disconnect the oil level sensor.





2. Remove the lower oil pan bolts.

Important: Do not damage the sealing surfaces when separating the lower oil pan from the upper oil pan.

3. Separate the lower oil pan from the upper oil pan using J37228.
4. Remove the lower oil pan.

Installation Procedure





1. Apply a 2 - 3 mm wide by 0.5 - 1.5 mm high bead of P/N 97720043 sealant to the lower oil pan mating surface.





2. Install the lower oil pan.





Notice: Refer to Fastener Notice in Service Precautions.

3. Install the lower oil pan bolts and nuts.
Tighten the lower oil pan bolts and nuts in sequence to 10 Nm (89 inch lbs.).





4. Connect the oil level sensor.