Installation

Fuel Rail

Installation







1. Tighten the fuel rail bracket using the specified mounting torque.

Tightening torque: 19 N.m (14 lb ft)

2. Tighten the fuel rail using the specified mounting torque.

Tightening torque: 19 N.m (14 lb ft)







3. Tighten the fuel leak off pipe (1) using the mounting eyebolt and the clip using the specified torque.

Tightening torque
(2): 18 N.m (13 lb ft)
(3.): 12 N.m (9 lb ft)
(4): 8 N.m (6 lb ft)
(7): 6 N.m (4 lb ft)

4. Tighten the fuel pipe (5) using the mounting sleeve nut and the specified torque.

Tightening torque
(6): 44 N.m (33 lb ft)
(8): 44 N.m (33 lb ft)

CAUTION: The fuel pipe (5) has a specific orientation. Thus, the sleeve nut is to be mounted such that its surface treated color is yellow on the fuel rail side and green on the fuel supply pump side.







5. Tighten the injection pipe and the clip using the specified mounting torque.

Injection pipe sleeve nut
Tightening torque: 44 N.m (33 lb ft)

Injection pipe clip
Tightening torque: 6 N.m (4 lb ft)

- Apply a thin coat of engine oil on the periphery of the sleeve nut on the fuel injector side and assemble.







6. Install the gasket to the EGR valve and tighten the bolts to the specified torque.

Tightening torque: 24 N.m (17 lb ft)

7. Install the gasket to the EGR adapter and tighten the bolts to the specified torque.

Tightening torque: 24 N.m (17 lb ft)







8. Install the air intake duct.
- Connect the connector for the intake air temperature sensor.