56. Oil Pump Clean and Inspect

Oil Pump Cleaning and Inspection





Caution: Refer to Cleaning Solvent Caution in Service Precautions.

1. Clean all parts of sludge, oil, and varnish by soaking in cleaning solvent.
2. Inspect for foreign material and determine the source of the foreign material.
3. Inspect the pump housing and cover for these conditions:
^ Cracks or casting imperfections
^ Scoring (3)
^ Damaged threads
4. Do not attempt to repair the pump housing.Replace the pump housing.
5. Inspect the oil pump gears for these conditions:
^ Scoring (1)
^ Excessive wear (2)
6. Inspect the idler shaft for looseness or scoring (4).If loose or damaged, replace the oil pump.
7. Inspect the drive gear shaft for looseness or scoring (5).





8. Inspect the pressure regulator valve for these conditions:
^ Scoring
^ Sticking - Burrs may be removed using a fine oil stone.
9. Inspect the pressure regulator valve spring for these conditions:
^ Loss of tension
^ Bending
10. Inspect the suction pipe and screen assembly for these conditions:
^ Looseness - If the suction pipe is loose, bent or has been removed, replace the pump body cover and suction pipe.
^ Broken wire mesh or screen





11. Measure the oil pump gear lash. Install the gears, and measure in several places.





12. Measure the oil pump housing gear pocket (1, 2).





13. Measure the oil pump gears (1, 2).





Important: When deciding pump serviceability based on end clearance, consider depth of the wear pattern in the pump cover.

14. Measure the oil pump gear side clearance.