Hood Latch Release Cable: Service and Repair

Hood Latch Release Cable Replacement

Removal Procedure

1. Open and support the hood.




2. Remove the hood latch cable (2) from the hood latch (1).




3. Remove the hood latch cable retaining clips (2).
4. Attach a length of mechanics wire to the hood latch cable prior to removal. This lead will assist in reinstallation of the new hood latch cable.
5. Remove the hood release handle. Refer toHood Latch Release Handle Replacement (Hood Latch Release Handle Replacement) .




6. Remove the hood latch cable and grommet rearward from the passenger compartment.




7. Transfer the lead wire to the new hood latch cable (1).



Installation Procedure





1. Using the lead wire, pull the new hood latch cable through the dash panel and into the engine compartment.
2. Seat the grommet fully into the dash panel.
3. Install the hood release handle. Refer toHood Latch Release Handle Replacement (Hood Latch Release Handle Replacement) .




4. Install the hood latch cable (2) to the hood latch (1).




5. Install the hood latch cable retaining clips (2).
6. Close the hood.