Transfer Case Input Shaft Seal Replacement

Transfer Case Input Shaft Seal Replacement

^ Tools Required
- J 42738 Seal Installer

Removal Procedure





1. Remove the transfer case.
2. Using a flat-tipped screwdriver, remove the input shaft seal.

Installation Procedure

Important: When installing the input shaft seal, make sure that the part numbers on the seal are facing outward (away from the body of the transfer case).





1. Align the transfer case input shaft seal evenly on the input shaft.

Important: The input shaft seal should be even with the surface of the transfer case after installation.

2. Using the J 42738 , install the transfer case input shaft seal.
3. Install the transfer case.
4. Check the fluid level. Add fluid if necessary.