Transfer Case Output Shaft Seal Replacement - Rear

Transfer Case Output Shaft Seal Replacement - Rear

^ Tools Required
- J 45756 Output Shaft Seal Installer

Removal Procedure





1. Remove the transfer case shield, if equipped.
2. Remove the rear propeller shaft.
3. Remove the rear output shaft seal by prying it out with a flat-tipped screwdriver.

Installation Procedure





1. Using the J 45756, install a NEW output shaft seal.
2. Install the rear propeller shaft.
3. Check the fluid level. Add fluid if necessary.
4. Install the transfer case shield, if equipped.