Multifunction Alarm Module Replacement

MULTIFUNCTION ALARM MODULE REPLACEMENT

REMOVAL PROCEDURE
The multifunction alarm (1) is located in the upper right corner of the rear of the instrument cluster (2).




1. Disconnect the negative battery cable.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

2. Remove the instrument cluster.
3. Remove the following from the rear of the instrument cluster (2):
3.1. The multifunction alarm retainer
3.2. The multifunction alarm (1)

INSTALLATION PROCEDURE




1. Install the multifunction alarm (1) to the rear of the instrument cluster (2). Secure the alarm with the retainer.
2. Install the instrument cluster.
3. Connect the negative battery cable.