Zone 3

1. Remove the key from the ignition switch.




2. Install the yellow 2-way connector (1) and install the CPA (2) for the inflatable restraint steering wheel module and the steering wheel side cap.
3. Install the I/P steering column opening trim plate.
4. Install the AIR BAG fuse (3) to the inline fuse holder.
5. Staying well away from both air bags, turn the ignition switch to the ON position. Verify that the AIR BAG warning indicator flashes seven times and then stays OFF. If the AIR BAG warning indicator does not operate as described, refer to Diagnostic System Check - Restraint Systems.