Parking Brake Warning Switch: Service and Repair

Park Brake Warning Lamp Switch Replacement

Removal Procedure

Caution: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.





2. Remove the MID-bussed electrical center from the bracket.
3. Remove the park brake warning lamp switch electrical connector.





4. Remove the park brake warning lamp switch mounting bolt.
5. Remove the park brake warning lamp switch.

Installation Procedure





1. Install the park brake warning lamp switch.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the park brake warning lamp switch mounting bolt.
Tighten the bolt to 3 Nm (25 inch lbs.).





3. Connect the park brake warning lamp switch electrical connector.
4. Install the MID-bussed electrical center to the bracket.
5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnect/Connect Procedure in Starting and Charging.