C0110

DTC C0110

Test 1-4:

Test 5-13:

Circuit Description
Ground is continuously supplied to the low side of the ABS pump motor. The EBCM activates the ABS pump by supplying battery voltage to the high side of the motor.

Conditions for Running the DTC
The ignition is ON.
^ The vehicle speed is greater than 6 km/h (4 mph).

Conditions for Setting the DTC
The EBCM detects an open pump motor circuit, a shorted pump motor, or a seized pump motor or ABS pump.

Action Taken When the DTC Sets
^ The EBCM disables the ABS/VSES.
^ The TCS operates with engine torque reduction ability only.
^ The ABS indicator turns ON.
^ The message center displays the service stability system message.

Conditions for Clearing the DTC
The Conditions for Setting the DTC are no longer present and you use the scan tool Clear DTCs function.

Diagnostic Aids
Separate the EBCM from the BPMV in order to inspect for corrosion or any other condition that may cause a poor connection at the pump motor connector. Refer to Electronic Brake Control Module (EBCM) Replacement (w/ JL4) or Electronic Brake Control Module (EBCM) Replacement (w/o JL4) and Testing for Intermittent and Poor Connections. If severe corrosion or other damage exists, the BPMV or the EBCM may need to be replaced.

Test Description
The number below refers to the step number on the diagnostic table.
4. This step tests for high resistance in the battery positive voltage circuit by verifying that an excessive voltage drop does not occur in the circuit.