P0128
CIRCUIT DESCRIPTIONAn engine coolant temperature (ECT) sensor monitors the temperature of the coolant. This input is used by the powertrain control module (PCM) for engine control and as an enabling criteria for some diagnostics.
The air flow coming into the engine is accumulated and used to determine if the engine has been driven within conditions that would allow the engine coolant to heat up normally to the thermostat regulating temperature. If the coolant temperature does not increase normally or does not reach regulating temperature of the thermostat, diagnostics that use ECT as enabling criteria may not run when expected.
This DTC will only run once per ignition cycle within the enabling condition. If the PCM detects the calibrated amount of air flow and engine run time have been met, and the ECT has not met the minimum thermostat regulating temperature, DTC P0128 sets.
CONDITIONS FOR RUNNING THE DTC
- DTCs P0101, P0102, P0103, P0112, P0113, P0116, P0117, P0118, P0125, P0500, P0502, P0503 are not present.
- The coolant temperature is -40°C (-40°F) or more.
- The coolant temperature is less than 70°C (158°F).
- The intake air temperature (IAT) is -7°C (19°F) or more.
- The engine has been running for more than 2 minutes, and for less than 23 minutes.
- The vehicle speed is more than 8 km/h (5 mph) for more than 2.5 km (1.5 miles).
- The mass air flow (MAF) average reading more than 23 g/s.
CONDITIONS FOR SETTING THE DTC
- The calibrated amount of air flow has been met.
- The calibrated amount of engine run time has been met.
- The minimum ECT for thermostat regulating of 75°C (167°F) has not been met.
ACTION TAKEN WHEN THE DTC SETS
- The control module illuminates the malfunction indicator lamp (MIL) on the second consecutive ignition cycle that the diagnostic runs and fails.
- The control module records the operating conditions at the time the diagnostic fails. The first time the diagnostic fails, the control module stores this information in the Failure Records. If the diagnostic reports a failure on the second consecutive ignition cycle, the control module records the operating conditions at the time of the failure. The control module writes the operating conditions to the Freeze Frame and updates the Failure Records.
CONDITIONS FOR CLEARING THE MIL/DTC
- The control module turns OFF the malfunction indicator lamp (MIL) after 3 consecutive ignition cycles that the diagnostic runs and does not fail.
- A current DTC, Last Test Failed, clears when the diagnostic runs and passes.
- A history DTC clears after 40 consecutive warm-up cycles, if no failures are reported by this or any other emission related diagnostic.
- Clear the MIL and the DTC with a scan tool.
TEST
Steps 1-4:
Steps 5-8:
