B2483

DTC B2483

CIRCUIT DESCRIPTION
The Navigation Antenna is connected to the Vehicle Communication Interface Module with a RG-174 coax cable. The Vehicle Communication Interface Module polls the data from the Navigation antenna once every second.

CONDITIONS FOR RUNNING THE DTC
- The ignition must be in the RUN or ACC position.
- The system voltage is at least 9.5 volts and no more than 15.5 volts.
- All the above conditions are present for greater than 1 second.

CONDITIONS FOR SETTING THE DTC
- The Vehicle Communication Interface Module does not detect a Navigation signal.
- All the above conditions are present for greater than 1 second.

ACTION TAKEN WHEN THE DTC SETS
- The OnStar(R) status LED turns RED.
- The OnStar(R) Call Center cannot locate the vehicle.

CONDITIONS FOR CLEARING THE DTC
- The Vehicle Communication Interface Module detects the presence of a Navigation antenna.
- A history DTC clears after 50 malfunction free ignition cycles.
- The Vehicle Communication Interface Module receives the clear DTC command from the scan tool.

TEST

Steps 1-3:

Steps 4-8: