Control Arm
| Front | Lower Control Arm Nuts-at Frame This is a prevailing torque type fastener. This fastener may be reused ONLY if: The fastener and its counterpart are clean and free from rust. (Note continues in next cell) | 83 ft. lbs. The fastener develops a specified amount of torque (drag) against its counterpart prior to the fastener seating If the fastener does not meet these criteria, REPLACE the fastener. |
| Rear | Control Arm Nut This is a prevailing torque type fastener. This fastener may be reused ONLY if:The fastener and its counterpart are clean and free from rust (Note continues in the next cell) | 162 ft. lbs. The fastener develops a specified amount of torque (drag) against its counterpart prior to the fastener seating. |
| Lower Control Arm to Crossmember | 37 ft. lbs. | |
| Lower Control Arm to Crossmember Cam Nut | 92 ft. lbs. | |
| Upper Control Arm to Crossmember | 63 ft. lbs. | |
| Upper Control Arm to Knuckle | 63 ft. lbs. | |
| Rear Axle Tie Rod Bolt | 92 ft. lbs. | |
| Rear Axle To Hub Nut | 118 ft. lbs. |