Valve Rocker Arm Cover Replacement (Left)

Valve Rocker Arm Cover Replacement- Left

Removal Procedure





1. Remove the engine cover.
2. Disconnect the spark plug wires from the distributor cap.
3. Remove the PCV valve from the valve rocker arm cover and set it aside.
4. Disconnect the ECT sensor electrical connector.
5. Remove AIR bypass hose assembly, if so equipped.
6. In order to gain access, remove the A/C compressor, if equipped.
7. Remove the power steering pulley from the power steering pump.





8. Remove the power steering pump mounting bracket.
9. Lay the power steering pump and the power steering pump bracket aside.





10. Remove the left valve rocker arm cover and gasket from the engine.
11. Clean all sealing surfaces.

Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the left valve rocker arm cover and gasket to the engine.
- Tighten the bolts to 12 Nm (106 inch lbs.).
2. Install the power steering pump bracket.
3. Install the Power Steering Pump.
4. Install the A/C compressor, if equipped.
5. Connect the ETC sensor electrical connector.
6. Install the PCV valve to the valve rocker arm cover.
7. Install AIR bypass hose assembly, if so equipped.
8. Connect the spark plug wires to the distributor cap.
9. Install the engine cover.