Trunk / Liftgate Shock / Support: Service and Repair

Cargo Door Assist Rod Replacement

Removal Procedure

Caution: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.


1. Open and support the cargo door.
Notice: Refer to Liftgate/Hood Assist Rod Notice in Cautions and Notices.






2. Lift up the retainer clips on the assist rods using a small flat-bladed tool.




3. Remove the upper end of the assist rods from the ball joint.




4. Remove the lower end of the assist rods from the ball joint.
5. Remove the assist rods from the cargo door.




6. Remove ball stud bolts.
7. Remove ball stud bracket.



Installation Procedure

1. Position the assist rods to the cargo door.




2. Install the upper end of the assist rods to the ball joint. Press in to place until fully seated.




3. Install ball stud bracket.
4. Install ball stud bolts.

Tighten to 20 N.m (15 lb ft)





5. Install the lower end of the assist rods to the ball joint. Press in to place until fully seated.
6. Remove the support from the cargo door.
7. Close the cargo door.