Audio/Video Interface Module Replacement (Luxury Y91)

REMOVAL PROCEDURE




1. Remove the left body side-trim panel.
2. Disconnect the electrical connectors from the rear-seat audio tee (RSAT) module.
3. Remove the double-sided tape from the back of the RSAT module (1) using a plastic flat-bladed tool.
4. Remove the RSAT module from the vehicle.
5. Remove all of the adhesive residue by using a razor knife and an isopropyl alcohol.

INSTALLATION PROCEDURE

IMPORTANT: Verify that all of the adhesive has been removed from the vehicle mounting surface.




1. Apply a double-sided tape to the RSAT module (1).
2. Install the RSAT module to the vehicle.
3. Connect the electrical connectors to the RSAT module.
4. Install the left body side-trim panel.

"For a description of the RPO Code(s) shown in this article or any of the images therein, refer to the RPO Code List found at Vehicle/Application ID". RPO Codes