Fuel Hose/Pipes Assembly Replacement (Passenger/Cargo Van Fuel Tank Pipes)

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
5. Remove the fuel feed and return pipes (6) from the fuel sender (1), the fuel filter, and the retaining clips.

INSTALLATION PROCEDURE




1. Install the fuel feed and return pipes (6) to the fuel sender (1), the fuel filter, and the retaining clips.
2. Install the fuel tank.
3. Lower the vehicle.
4. Refill the fuel tank.
5. Tighten the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks:
7.1. Turn ON the ignition for 2 seconds.
7.2. Turn OFF the ignition for 10 seconds.
7.3. Turn ON the ignition.
7.4. Inspect for fuel leaks.
8. Install the engine cover.