Idle Control Solenoid (ICS) Replacement
TOOLS REQUIREDJ 41416 Ultrasonic Leak Detector
REMOVAL PROCEDURE
1. Remove the engine cover.
2. Disconnect the fuel supply tube (4) at the solenoid.
3. Remove the spring clamp and fuel outlet hose from the solenoid.
4. Disconnect the electrical connector. The idle control solenoid connector is red.
5. Remove the 2 solenoid mounting bolts (6).
INSTALLATION PROCEDURE
NOTE: Refer to Fastener Notice in Service Precautions.
1. Position the solenoid (5) and install the 2 mounting bolts (6).
Tighten
Tighten the bolts to 12 N.m (106 lb in).
2. Connect the fuel outlet hose and spring clamp.
3. Connect the fuel supply tube (4).
4. Connect the electrical connector.
5. Start the engine and use the J 41416 in order to inspect for leaks at each serviced fitting.
6. Install the engine cover.