Secondary Air Injection (AIR) Pump Replacement

REMOVAL PROCEDURE
1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle.
2. Disconnect the pump electrical connector.
3. Disconnect vacuum lines from the solenoid.
4. Remove the pump/bracket assembly fasteners.
5. Reposition the pump and bracket assembly to gain access to the outlet hose.
6. Remove the outlet hose from the pump.
7. Remove the pump and bracket assembly from the vehicle.

INSTALLATION PROCEDURE
1. Transfer parts as necessary.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Attach the pump and bracket assembly to the frame rail using the fasteners.

Tighten
Tighten the fasteners to 10 N.m (89 lb in).

3. Connect the pump electrical connector.
4. Connect vacuum lines to the solenoid.
5. Install the outlet hose to the pump.
6. Lower the vehicle.