38. Transmission Range Switch Installation

1. Perform the following steps in order to install the transmission range switch:
1.1. Turn the manual shaft rearward.
1.2. Turn the shaft back two notches.
1.3. Set the shaft to the N range.
1.4. Install the switch.
1.5. Handstart the bolt.
1.6. Install the lock washer.
1.7. Install the set nut.

Notice: Refer to Fastener Notice in Service Precautions

^ Tighten the set nut to 5 Nm (44 inch lbs).
2. Bend the lock washer claws over the set nut.
3. With the neutral reference line (2) and the cutout in the switch (3) aligned, tighten the switch bolt.
^ Tighten the bolt to 5 Nm (44 inch lbs).
4. Install the manual lever to the manual shaft.
5. Install the manual shaft lever nut.
^ Tighten the nut to 13 Nm (115 inch lbs).
6. Install the vent hose to the vent elbow at the top of the transmission case.
7. Install the vent hose clamp.
8. Install a new O-ring to the fluid filler tube.
9. Install the fluid filler tube to the transmission case.
10. Install the fluid filler tube bolt.
11. Install the fluid level indicator to the fluid filler tube.
12. Remove the J 41626 with the transmission case from the J 3289-20.
13. Remove the J 41626 from the transmission case (1).





14. Install the three remaining converter housing bolts (2).
^ Tighten the bolts (4) to 36 Nm (27 ft. lbs.).
^ Tighten the bolts (3) to 58 Nm (43 ft. lbs.).