40. Oil Pump Assemble

1. Lubricate the following with clean engine oil.
^ The oil pump inner gear
^ The oil pump outer gear
^ The inside surface of the oil pump body

2. Install the oil pump outer and inner gears to the oil pump body.

Notice: Fill oil pump cavities with petroleum jelly prior to installation. This will ensure that there is oil pressure immediately on start-up and will prevent engine damage.

3. Fill the oil pump with petroleum jelly to prime the oil pump.

Notice: Refer to Fastener Notice in Service Precautions.





4. Install the relief valve (4), the spring (3) and the retainer (2).
^ Tighten the retainer to 29 Nm (21 ft. lbs.).
5. Install the oil pump cover to the oil pump body.
6. Secure the cover with 5 bolts.
^ Tighten the bolts to 12 Nm (9 ft. lbs.).