Overhaul Procedure Steps

NOTE: This article lists the sequential steps necessary to overhaul the transmission.
^ For the specific step listed below, refer to that step under "Repair Instructions".
^ For the complete list of procedures, refer to "Repair Instructions".




Overhaul Procedure:


[ ] Torque Converter Removal
[ ] Rear Adapter Case, Vehicle Speed Sensor Removal
[ ] Transmission Range Switch Removal
[ ] Valve Body, Accums, Solenoid Wiring Harness Removal
[ ] Fluid Pan, Filter Screen and Fluid Pipes Removal

[ ] Parking Pawl and Manual Shift Linkage Removal
[ ] Oil Pump and Torque Converter Housing Removal
[ ] Overdrive Clutch Drum and Overdrive Case Removal
[ ] Forward and Direct Clutch Assembly Removal
[ ] Center Support and Planetary Sun Gear Removal

[ ] Reverse Brake Piston Removal
[ ] Planetary Gears and Output Shaft Removal
[ ] Case Assembly Cleaning and Inspection
[ ] Planetary Gears and Output Shaft Overhaul
[ ] Center Support Reconditioning Repair

[ ] Direct Clutch Overhaul Measurement Procedure
[ ] Forward Clutch Overhaul
[ ] Oil Pump Overhaul
[ ] Overdrive Overhaul (Planetary Gear Side)
[ ] Overdrive Overhaul (Case Side)

[ ] Valve Body Removal
[ ] Front Upper Valve Body Disassemble
[ ] Front Upper Valve Body Assemble
[ ] Rear Upper Valve Body Disassemble
[ ] Rear Upper Valve Body Assemble

[ ] Lower Valve Body Disassemble
[ ] Lower Valve Body Assemble
[ ] Valve Body Installation
[ ] Reverse Brake Piston Installation
[ ] Planetary Gears and Output Shaft Installation

[ ] Center Support and Planetary Sun Gear Installation
[ ] Forward and Direct Clutch Assembly Installation
[ ] Overdrive Clutch Drum, Overdrive Case Installation
[ ] Oil Pump and Torque Converter Housing Installation
[ ] Valve Body, Accums, Solenoid Wiring Harness Inst

[ ] Fluid Pan, Filter Screen, Fluid Pipes Installation
[ ] Rear Adapter Case, Vehicle Speed Sensor Install
[ ] Transmission Range Switch Installation
[ ] Torque Converter Inspection
[ ] Torque Converter Installation