Automatic Level Control Sensor Link Ball Stud Replacement

Removal Procedure





1. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
2. Remove the automatic level control sensor link from the rear differential bracket ball stud.
3. Remove the automatic level control sensor link ball stud from the rear differential bracket.


Installation Procedure

Notice: Refer to Fastener Notice in Service Precautions.





1. Install the automatic level control sensor link ball stud to the rear differential bracket.
- Tighten the automatic level control sensor link ball stud to 4 Nm (35 inch lbs.).

Notice: When you are servicing the automatic level control sensor link, ensure that the sensor link and the sensor arm are not damaged. Ensure the sensor arm and the sensor link are properly oriented. Improper orientation of the sensor arm and the sensor link may cause damage to the automatic level control system or the vehicle.

2. Install the automatic level control sensor link to the rear differential bracket ball stud.
3. Lower the vehicle.