Steering Wheel Control Switches Replacement
Steering Wheel Control Switches ReplacementREMOVAL PROCEDURE
1. Remove the steering wheel module.
2. Remove the horn switch plunger.
3. Remove the steering wheel redundant control switch mounting screws.
4. Disconnect the steering wheel redundant control switch electrical connector.
5. Remove the steering wheel redundant control switch from the steering wheel.
INSTALLATION PROCEDURE
1. Install the steering wheel redundant control switch to the steering wheel.
2. Connect the steering wheel redundant control switch electrical connector.
NOTE: Refer to Fastener Notice in Service Precautions.
3. Install the steering wheel redundant control switch mounting screws.
Tighten
Tighten the steering wheel redundant control switch mounting screws to 2 N.m (20 lb in).
4. Install the horn switch plunger.
5. Install the steering wheel module.