Turn Signal Cancel Cam & Upper Bearing Inner Race - Disassemble

- Tools Required
- J 23653-SIR Lock Plate Compressor

Important: Let the inflatable restraint steering wheel module coil hang freely after removal.





1. Remove the inflatable restraint steering wheel module coil. Refer to Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle (Column Shift) or Inflatable Restraint Steering Wheel Module Coil - Disassemble - Off Vehicle (Floor Shift).
2. Compress the shaft lock shield assembly (2) using J 23653-SIR.
3. Remove the bearing retainer (1) from the steering shaft assembly.
4. Discard the bearing retainer (1).
5. Remove J 23653-SIR from the steering shaft assembly.





6. Remove the following parts from the steering shaft assembly:
- The shaft lock shield assembly (5)
- The turn signal cancel cam assembly (4)
- The upper bearing spring (3)
- The upper bearing inner race seat (2)
- The inner race (1)