Electric Park Lock Module - Disassemble

- Tools Required
- J 41352 Modular Column Holding Fixture
- J 42640 Steering Column Anti Rotation Pin





1. Put the steering column and J 41352 into a vise.
2. Insert J 42640 into the lower trim cover.





3. Use a small screwdriver to pull the filler plug out of the bottom of the lower trim cover.





4. Insert the small screwdriver into the filler plug hole in the bottom of the lower trim cover.
5. Use the screwdriver to push up on the manual override of the electric park lock (1).
6. Insert the key into the ignition.
7. Turn the key to the LOCK position. Remove the key.





8. Remove the 2 pan head tapping screws (1) from the lower trim cover (2).





9. Remove the lower trim cover from the upper trim cover in the following way:
9.1. Tilt the lower trim cover down.
9.2. Slide the lower trim cover backward in order to disengage the locking tabs.





10. Remove the 2 TORX head screws (1) from the upper trim cover (2).
11. Remove the upper trim cover (2) from the steering column.





12. Remove the black connector (2) from the electric park lock (1).





13. Pry the electric park lock (2) off of the electronic lock module assembly (1).