P Series

Disassembly Procedure





1. Drain the power steering fluid from the power steering pump.
2. Remove the connector and fitting assembly (4).
3. Remove the O-ring seal (3).





4. Remove the control valve assembly (3) and the flow control spring (2) from the pump housing assembly (1).

Assembly Procedure





1. Install the flow control spring (2) to the pump housing assembly (1).
2. Install the control valve assembly (3) to the flow control spring (2).





3. Install the O-ring seal (3) to the connector and fitting assembly (4).

Notice: Refer to Fastener Notice in Service Precautions.

4. Install the connector and fitting assembly (4) to the pump housing (1).
- Tighten the connector and fitting assembly (4) to 75 Nm (55 ft. lbs.).