P/S Cooler Pipe/Hose Replacement

Removal Procedure

Notice: Refer to Power Steering Hose Disconnected Notice in Service Precautions.





1. Remove the air cleaner assembly.
2. Install a drain pan under the vehicle.
3. Disconnect the power steering cooler hose from the power steering pump.





4. Disconnect the power steering cooler hose from the power steering cooler.
5. Remove the power steering cooler hose from the vehicle.

Installation Procedure

Notice: The inlet and outlet hoses must not be twisted during installation. Do not bend or distort the inlet or outlet hoses to make installation easier. Failure to follow these procedures could result in component damage.





1. Install the power steering cooler hose to the vehicle.

Notice: Refer to Fastener Notice in Service Precautions.

2. Connect the power steering cooler hose to the power steering cooler.
- Tighten the power steering cooler hose to the power steering cooler clamp to 2 Nm (18 inch lbs.).





3. Connect the power steering cooler hose to the power steering pump.
- Tighten the power steering cooler hose to the power steering pump clamp to 2 Nm (18 inch lbs.).
4. Remove the drain pan from under the vehicle.
5. Install the air cleaner assembly.
6. Bleed the power steering system. Refer to Bleeding the Power Steering System.