Knee Bolster Replacement

KNEE BOLSTER REPLACEMENT

Removal Procedure








1. Turn the ignition switch to the LOCK position.

2. Remove the left sound insulator. Refer to Service and Repair

3. Remove the knee bolster trim panel. Refer to Instrument Panel (IP) - Trim Panel Replacement - Knee Bolster

4. Remove the instrument panel accessory trim plate. Refer to Service and Repair

5. Remove the nuts that retain the knee bolster from the steering column support.

6. Remove the knee bolster from the studs.

Installation Procedure






1. Remove the knee bolster to the studs.

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring or fasteners requiring the use of the thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the nuts that retain the knee bolster to the steering column support.

3. Tighten the nuts to 10 Nm (89 lb.in).

4. Install the instrument panel accessory trim plate. Refer to Service and Repair

5. Install the knee bolster trim panel. Refer to Service and Repair

6. Install the left sound insulator. Refer to Service and Repair