Turn Signal Flasher: Service and Repair

REMOVAL PROCEDURE




1. Open the glove box to expose the glove box retaining tab (1).
2. Lift the retaining tab and allow the glove box to hang freely.




3. Using a suitable flat-bladed tool, release the plastic retainer that retains the Hazard/Turn Signal Flasher (1) to the C203 body harness connector (2).
4. Remove the hazard/turn signal flasher (1).

INSTALLATION PROCEDURE




1. Install the Hazard/Turn Signal Flasher (1) to the C203 body harness connector (2).
2. Install the plastic retainer and ensure the hazard/turn signal flasher will not work its way loose over time.




3. Lift the glove box retaining tab (1) to install the glove box to its original position.
4. Close the glove box.