Vacuum Solenoid Valve HVAC: Service and Repair

VACUUM ELECTRICAL SOLENOID REPLACEMENT

REMOVAL PROCEDURE




1. Remove the instrument panel carrier.
2. Disconnect the electrical connector (4) from the vacuum electrical control solenoid (5).
3. Disconnect the vacuum harness connector from the vacuum electrical control solenoid.




4. Remove the vacuum electrical control solenoid retaining screws.
5. Remove the vacuum electrical control solenoid from the vehicle.

INSTALLATION PROCEDURE




1. Install the vacuum electrical control solenoid to the vehicle.

NOTE: Refer to Fastener Notice in Service Precautions.

2. Install the vacuum electrical control solenoid retaining screws.

Tighten
Tighten the vacuum electrical control solenoid retaining screws to 2 N.m (18 lb in).




3. Connect the vacuum harness connector to the vacuum electrical control solenoid.
4. Connect the electrical connector (4) to the vacuum electrical control solenoid (5).
5. Install the instrument panel carrier.