Compressor Shaft Seal Removal (HT6 - Direct Mount)

TOOLS REQUIRED
^ J 41790 Compressor Holding Tool
^ J 42136 A/C Lip Seal Remover




1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J 41790 in a vise and attach the compressor to the J 41790.




3. Remove the compressor clutch plate and hub assembly.
4. Using internal snap ring pliers (1), remove the compressor shaft seal retainer ring (2).
5. In order to prevent any dirt or foreign material from entering the compressor, thoroughly clean the following components:
^ The inside of the compressor neck area surrounding the shaft
^ The exposed portion of the compressor shaft seal
^ The compressor shaft
^ The O-ring groove




6. Fully engage the lip of the J 42136 into the recessed portion of the seal (1) by turning the handle clockwise.
7. Remove the compressor shaft seal from the compressor with a rotary pulling motion.
8. Recheck the shaft and inside of the compressor neck for dirt or foreign material and make sure these areas are perfectly clean before installing the new compressor shaft seal.