Compressor Clutch Plate & Hub Assy Removal(HT6-Direct Mount)

TOOLS REQUIRED
^ J 33013-B Hub and Drive Plate Remover/Installer
^ J 33027-A Clutch Hub Holding Tool
^ J 41790 Compressor Holding Fixture




1. Remove the compressor from the vehicle.
2. Remove the compressor from the vehicle.
3. Clamp the compressor holding fixture, J 41790 in a vise and attach the compressor to the J 41790.




4. Ensure that the center screw forces the tip to thrust against the end of the shaft.
5. While holding the body of the J 33013-B with a wrench, turn the center screw into the remover body in order to remove the clutch plate and hub assembly (1).
6. Remove the compressor shaft nut with a 13 mm socket (1).




7. Thread the J 33013-B into the hub.
8. Remove the hub and drive plate assembly (1) by turning the center screw into the body of the J 33013-B and against the compressor shaft.
9. Remove the shaft key and retain for reassembly.