Compressor Clutch Coil Removal (HT6 - Direct Mount)

TOOLS REQUIRED
^ J 8433 Compressor Pulley Puller
^ J 8433-3 Forcing Screw
^ J 33023-A Puller Pilot
^ J 33025 Clutch Coil Puller Legs
^ J 41790 Compressor Holding Fixture




1. Remove the compressor from the vehicle.
2. Clamp the compressor holding fixture, J 41790 in a vise and attach the compressor to the J 41790.




3. Remove the compressor clutch plate and hub assembly.
4. Install the J 33023-A onto the front head of the compressor.
5. Remove the compressor clutch rotor and bearing assembly.




6. Mark the clutch coil terminal location (2) on the compressor front head.
7. Install the J 33025 onto the J 8433.
8. Install the J 8433 onto the compressor clutch coil (1) and tighten the puller leg bolts.
9. Tighten the center forcing screw J 8433-3 of the compressor pulley puller J 8433 against the J 33023-A to remove the compressor clutch coil from the compressor.
10. Remove the J 8433-3, the J 33023-A, the J 33025 and the J 8433.