Coolant Reservoir: Service and Repair

Removal Procedure





1. Remove the VCM/PCM and set it aside. Refer to VCM Replacement/Programming or PCM Replacement/Programming.

Important: Do not disconnect wiring harness to VCM/PCM.

2. Disconnect the hose from the coolant recovery reservoir.





3. Remove the coolant recovery reservoir retaining nuts.





4. Remove the coolant recovery reservoir.
5. Remove the coolant from the reservoir.

Installation Procedure





1. Install the coolant recovery reservoir.





Notice: Refer to Fastener Notice in Service Precautions.

2. Tighten the reservoir retaining nuts.

^ Tighten the reservoir retaining nuts to 8 - 11 Nm (6 - 8 ft. lbs.)





3. Connect the hose to the coolant recovery reservoir.
4. Install the VCM/PCM. Refer to VCM Replacement/Programming or PCM Replacement/Programming.
5. Add coolant to reservoir. Refer to Draining and Filling Cooling System.