Park Brake Cable Mounting Bracket Replacement

Removal Procedure





1. Release the parking brake.
2. Raise and support the vehicle. Refer to Vehicle Lifting.
3. Release the tension on the cables by loosening the nut at the equalizer.
4. Disconnect the rear cables from the equalizer.
5. Remove the rear cables from the mounting bracket by depressing the retaining tabs and pulling rearward.





6. Remove the cable support bracket bolt.
7. Remove the cable support bracket.

Installation Procedure





1. Install the cable support bracket.

Notice: Refer to Fastener Notice in Service Precautions.

2. Install the cable support bracket bolt.
Tighten
Tighten the cable support bracket bolt to 17 Nm (12.6ft. lbs.).





3. Install the rear cables to the mounting bracket by inserting the cable till all the retaining tabs snap into place.
4. Connect the rear cables to the equalizer.
5. Tighten the equalizer nut to the intermediate cable at the equalizer.
Tighten
Tighten the equalizer nut to 3.5 Nm (31 inch lbs.).
6. Remove the safety stands.
7. Lower the vehicle.
8. Check the operation of the park brake.