Front Floor Console Replacement - Full Length Manual Trans

FRONT FLOOR CONSOLE REPLACEMENT (FULL LENGTH FOR MANUAL TRANS)

Removal Procedure






1. Remove the shift control lever (manual transmission only).

2. Remove the cup holder insert.

3. Remove the screws that retain the trim plate to the console.

4. Remove the trim plate from the console.






5. Open the storage compartment cover.

6. Remove the storage compartment.







7. Remove the nuts that retain the console to the vehicle.

8. Remove the electrical connector, if equipped.

9. Remove the console from the vehicle.

Installation Procedure






1. Install the console to the vehicle.

2. Install the electrical connector, if equipped.

NOTICE: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring or fasteners requiring the use of the thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the nuts that retain the console to the vehicle.

4. Tighten the nuts to 10 Nm (88 lb.in).






4. Install the storage compartment to the vehicle.






5. Install the trim plate to the console.

6. Install the screws that retain the trim plate to the console.

7. Tighten the nuts to 1.9 Nm (17 lb.in).

8. Install the cup holder insert.

9. Install the shift control lever (manual transmission only).