Lower Side Moulding / Trim: Service and Repair

Body Side Molding Replacement (Chevrolet)

Tools Required

J 25070Heat Gun

Removal Procedure




1. Heat the body side molding using a J 25070. Hold the heat gun approximately 152 mm (6 in) from surface.
Apply heat using a circular motion for about 30 seconds.

Important: Be careful not to scratch or chip the paint.

2. Peel the body side molding from the panel surface using a flat-bladed tool.
3. Remove all adhesive from the body panel and the back of the body side molding using a 3M(TM) scotch brite molding adhesive remover disk 3M(TM) P/N 07501 or equivalent.
4. Clean the body panel using Varnish Makers and Painters (VMP) naphtha.

Installation Procedure




1. Warm body panel with a heat lamp or heat gun to a minimum of 21°C (70°F).
2. Peel the backing from the front end of the body side molding.

Important: Do not touch the adhesive backing.

3. Press the body side molding to the body while continuing to remove the backing.
4. Hand roll the body side molding to the body in order to ensure proper adhesion.