Marker Lamp Replacement - Side (RPO X88/Z88)

REMOVAL PROCEDURE
1. Remove the screw (4) that retains the side marker or the reflector to the radiator grille.
2. Remove the side marker lamp (3) or the reflector (5) from the radiator grille.
3. Disconnect the bulb socket (2) from the side marker lamp.
4. Remove the bulb (2) from the socket by turning the bulb in a counter-clockwise direction.

INSTALLATION PROCEDURE
1. Connect the bulb (2) into the socket.
2. Connect the bulb socket (2) into the side marker lamp.
3. Install the side marker lamp (3) or the reflector (5) to the radiator grille (1).

NOTE: Refer to Fastener Notice in Service Precautions.

4. Install the side marker lamp or reflector retaining screw (4) to the radiator grille.

Tighten
Tighten the screws to 1.5 N.m (13 lb in).

For a Description of RPO Code(s) shown in this article refer to the RPO Code List found at Vehicle/Application and ID Application and ID