Rear

Removal Procedure





1. Complete the lever pin up procedure. Refer to Enabling the Park Brake Automatic Adjuster.
2. Loosen the cable at the cable adjuster.
3. Disconnect the front cable from the rear cables.
4. Remove the rear brake shoes from the backing plate.
5. Disconnect the cable from the backing plate retainer.





6. Remove the rear cable from the vehicle.

Installation Procedure





1. Install the rear cable to the vehicle.
2. Connect the rear cable to the backing plate retainer.
3. Connect the rear brake shoes to the backing plate.





4. Connect the front cable to the rear cables.





5. Remove the pin (1) from the lever.
6. Place the lever to the FULL up position.





7. Measure the threads of the equalizer. Adjust the threads to the following specifications:
^ Passenger/Cargo to 13 mm (0.51.1 inch)
^ Cutaway/Upfitters to 21 mm (0.826 inch)
8. Verify that the vehicle will hold the position with the brake lever depressed.
9. If additional adjustments need to be made, refer to Park Brake Cable Service/Adjustment.