Keyless Entry Transmitter Battery: Service and Repair

REMOVAL PROCEDURE




1. Insert a small coin between the two halves of the transmitter case at the slot provided near the key ring hole.
2. Twist the coin in order to open the case.
3. Open the transmitter case.

NOTE: Refer to ESD Notice in Service Precautions.




4. Remove the battery (2).

INSTALLATION PROCEDURE




1. Install the battery (2) with the positive (+) side down.
Use one 3 V CR2032 battery (or the equivalent).




2. Ensure that the seal is in position. Align the two halves of the case and snap the two halves together.
3. Resynchronize the transmitter. Refer to Transmitter Synchronization (Domestic).
4. Replace the batteries when the range of the transmitter decreases to less than 7 meters (23 feet).