Knock Sensor: Service and Repair

REMOVAL PROCEDURE

The Knock Sensor (KS) is located at the top rear of the engine.

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.




1. Disconnect the negative battery cable.
2. Remove the engine cover.
3. Disconnect the KS harness connector.




4. Remove the KS from the rear of the engine.

INSTALLATION PROCEDURE

NOTE: Refer to Component Tightening Notice in Service Precautions.




1. Install the knock sensor.

Tighten
Tighten the knock sensor to 19 N.m (14 lb ft).




2. Connect the KS harness connector.
3. Install the engine cover.