Cutaway Van Rear Tank Fuel Tank Pipes

REMOVAL PROCEDURE

Tools Required
J 34730-1A Fuel Pressure Gauge

CAUTION: Refer to Battery Disconnect Caution in Service Precautions.

1. Disconnect the negative battery cable.
2. Relieve the fuel system pressure. Refer to Fuel Pressure Relief Procedure.
3. Drain the fuel tank. Refer to Fuel Tank Draining Procedure.
4. Remove the fuel tank.
5. Remove the fuel feed and return pipes (4) from the fuel sender (2).

INSTALLATION PROCEDURE
1. Install the fuel feed and return pipes (4) to the fuel sender (2).
2. Install the fuel tank.
3. Lower the vehicle.
4. Refill the fuel tank.
5. Tighten the fuel filler cap.
6. Connect the negative battery cable.
7. Inspect for leaks:
7.1. Turn the ignition switch ON for 2 seconds.
7.2. Turn the ignition switch OFF for 10 seconds.
7.3. Turn the ignition switch ON.
7.4. Inspect for fuel leaks.
8. Install the engine cover.