Front Suspension

REMOVAL PROCEDURE





1. Raise and support the vehicle.
2. Remove the tire and, wheel assembly.
3. Remove the coil spring.
4. Remove the spring, rubber seat (1).
5. Remove the bump, stopper (3).

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.





1. Install the bump stopper (3).
^ Tighten the bump stopper to 50 Nm (36.5 ft. lbs.).

2. Install the spring rubber seat (1).
3. Install the coil spring.
4. Install the tire and wheel assembly.
5. Lower the vehicle.