Parking Brake Lever: Service and Repair

REMOVAL PROCEDURE





1. Release the park brake.
2. Remove the 4 screws (1,3,4,6), the 2 clips (2,5), and lift up the console.
3. If the vehicle has an automatic transmission, disconnect the power normal switch connector.
4. If the vehicle has an auxiliary power outlet, disconnect the auxiliary power outlet connector.





5. Disconnect the park brake switch connector (10).





6. Remove the park brake cable lock nut (1).





7. Remove the park brake lever bolts (1) and the park brake lever (2) from the equalizer (5).
8. Remove the pin (6) and the equalizer from the park brake cable (4).

INSTALLATION PROCEDURE

NOTICE: Refer to Fastener Notice in Service Precautions.

IMPORTANT: The equalizer must be within 15 degrees of perpendicular to the park brake lever cable.





1. Install the equalizer (5) to the park brake cable (4). Secure with the pin (6).
2. Install the park brake lever (2) to the equalizer. Secure with three bolts (1).
^ Tighten the bolts to 23 Nm (17 ft. lbs.).





3. Install the park brake cable lock nut (1).





4. Connect the park brake switch connector (10).
5. Adjust the park brake lever.





6. Position the console over the shift knob.
7. If the vehicle has an auxiliary power outlet, connect the auxiliary power outlet connector.
8. If the vehicle has equipped an automatic transmission, connect the power normal switch connector.
9. Install the console. Secure with 4 screws (1,3,4,6) and 2 clips (2,5).