Flywheel to Torque Converter Bolts

Removal Procedure





1. Raise the
vehicle. Refer to Vehicle Lifting.
2. Remove the starter.
3. Remove the converter housing access plug.
4. Mark the converter and flywheel for proper alignment for installation.





5. Remove the flywheel to converter bolts.

Installation Procedure





Notice: Refer to Fastener Notice in Service Precautions.

1. Install the flywheel to converter bolts. Hand start the bolts.
^ Tighten the bolts to 60 Nm (44 ft. lbs.).





2. Install the converter housing access plug.
3. Lower the vehicle.