Rear Drive Axle

Removal Procedure

Important: Prior to disassembly, observe and mark the positions of all the driveline components, relative to the propeller shaft and the axles, including the following components:
^ propeller shafts
^ drive axles
^ pinion flanges
^ output shafts

Reassemble all the components in the exact places in which you removed the parts. Follow any specifications, torque values, and any measurements obtained prior to disassembly.

1. Remove the drive pinion yoke/flange. Refer to Drive Pinion Yoke Replacement.
2. Remove the pinion oil seal. Use a suitable seal removal tool. Do not damage the carrier.
3. Inspect the seal surface of the pinion yoke/flange for the following conditions:
^ Tool marks
^ Nicks
^ Damage such as a groove worn by the seal
4. Inspect the carrier bore for burrs that may cause leaks around the outside of the seal.

Installation Procedure

^ Tools Required
- J 23911 Pinion Oil Seal Installer





1. Install a new pinion oil seal using the J 23911.
2. Install the drive pinion yoke/flange. Refer to Drive Pinion Yoke Replacement.