Automatic Level, Control Solenoid Valve Replacement

REMOVAL PROCEDURE

CAUTION: Refer to Battery Disconnect Caution in Cautions and Notices.





1. Disconnect the battery negative cable.
2. Remove the plastic cap from the load leveling air direction valve at the inflator fill valve.
3. Remove the retaining nut and washer from the load leveling air direction valve at the inflator fill valve.
4. Remove the body side trim panel. Refer to Trim Panel Replacement - Body Side (4-Door Utility) in Interior Trim.





5. Disconnect the air lines from the load leveling air direction valve.





6. Loosen the load leveling air direction valve to the body side trim panel mountings nut.
7. Remove the load leveling air direction valve from the body side trim panel.





8. Disconnect the electrical connector from the load leveling air direction valve.

INSTALLATION PROCEDURE





1. Connect the electrical connector to the load leveling air direction valve.
2. Install the load leveling air direction valve to the body side trim panel.





NOTICE: Refer to Fastener Notice in Service Precautions.

3. Tighten the load leveling air direction valve to the body side trim panel mountings nut.
- Tighten the load leveling air direction valve to body side trim panel mountings nut to 6 Nm (53 inch lbs.).





4. Connect the air lines to the load leveling air direction valve.
5. Install the body side trim panel. Refer to Trim Panel Replacement - Body Side (4-Door Utility) in Interior Trim.





6. Install the load leveling air direction valve washer and retaining nut at inflator fill valve.
- Tighten the load leveling air direction valve retaining nut at the inflator fill valve to 3 Nm (27 inch lbs.).
7. Install the plastic cap to the load leveling air direction valve at inflator fill valve.
8. Connect the battery negative cable.